$27,900
Kemah, Texas
Category
Sailboats
Length
30'
Posted Over 1 Month
1979 Endeavour 32' Sloop
PRICE REDUCED $7,000! SELLER SAYS SELL NOW!
The Endeavor 32 is known for her comfort and versatility and configured with a fixed shoal keel and 4'2" draft, extensive interior storage and access, fully equipped galley, integral companion way stairs, and a teak cabin sole.
The hull is molded as a single unit of a combination of polyester resin and fiberglass woven roving and multidirectional chopped strand fiber (MCSF). The keel is molded integrally with the hull and all ballast is contained inside. The deck and cockpit, like the hull, are molded as a single unit of a combination of polyester resin and fiberglass woven roving and MCSF. Plywood coring is incorporated between layers of fiberglass in the cabin top, deck, seat, and cockpit sole areas to give additional stiffness.
There is an anchor well at the bow with anchor rode into the vberth locker, teak grab rails on the cabin top and a large aft cockpit with good back rests and storage lockers. The companionway goes down to seat height, about 12" above the cockpit sole, and has three drop boards.
The rudder is molded as a single piece of solid high density foam with a protective skin of fiberglass and gelcoat finish. The rudder post, molded integrally with the rudder, is solid stainless steel, welded to a steel blade in the interior of the rudder. Where the rudder post passes through the hull, water tightness is ensured by means of a stuffing box. The steering system operates with stainless steel cables rotating a quadrant bolted and keyed to the rudder post.
All spars (mast, boom, and spreaders) are extruded aluminum alloy, with protective coating. The main mast is stepped on deck with a supporting post immediately under the mast inside the cabin. The standing rigging is made of stainless steel wire. The forestay attaches to the stem head fitting at the bow, fabricated of welded stainless steel back plates through bolted to the hull. All other stays and shrouds are attached to chainplates at the edge of the deck and are through bolted to the hull. Additional fiberglass reinforcement is molded into the hull in all chain plate areas. All halyards are run externally to #32 Lewmar winches mounted on the mast. Sheets are led to #40 Lewmar self tailing winches in the cockpit. Sheet lead blocks clip to the toerail. The main sheet traveler is mounted on the companionway 'bridge deck'.
The interior of the Endeavour 32 is a molded fiberglass unit with bulkheads and cabinetry fastened to it with screws, bolts, and adhesives. The entire unit is preassembled outside the boat and is bonded in place with woven roving and mat, that when completed, forms a single unit structure having great strength and rigidity.
The interior is finished with varnished teak with soft white overheads. The
