12 Ft Flat Bottom Jon Boat Boats for sale

1-5 of 5

Sort By

Jon boat Montgomery Wards Seaking 12FT aluminum flat bottom

$450

Washington, District Of Columbia

Year -

Make -

Model -

Category -

Length -

Posted Over 1 Month

Jon boat 12 ft Montgomery Wards Seaking. The two seats are in ok condition they will probably make it another season or 2. I do not have title but was last titled in my name so I can give a bill of sale

Jon boat Montgomery Wards Seaking 12FT aluminum flat bottom

$450

Fredericksburg, Virginia

Year -

Make -

Model -

Category -

Length -

Posted Over 1 Month

Jon boat 12 ft Montgomery Wards Seaking. The two seats are in ok condition they will probably make it another season or 2. I do not have title but was last titled in my name so I can give a bill of sale

2005 16ft Lowe Jon Boat 40hp Johnson Fishing Boat Flat Bottom Ducks Very Nice

$9,000

Ormond Beach, Florida

Year -

Make -

Model -

Category -

Length -

Posted Over 1 Month

For Sale is my 16 ft Lowe Jon Boat with a 2005 40hp Johnson tiller motor. The Boat is in great condition I use the boat regularly with my Wife and Son for fishing, Flounder Gigging, Diving, Scalloping, Shrimping, and just Cruising to the islands. This boat flies in runs about 25mph with the wife son and I in it. Boat can run in approx 6-8 in draft. Very skinny water capable. The Motor is a 2005 Johnson 40hp Electric Start and runs great. Last year just to be safe I went ahead and had prop seals replaced, and lower unit oil drained and filled fresh. There was never an issue just thought better be safe then sorry and get it done once a year. I treat this boat as if it was one of my children, everything needs to be perfect. 4th of July 2014 this year my family and I took this boat 12 miles roughly from the dock to the scallop grounds out in the Gulf of Mexico. Never missed a beat she ran beautifully on 6 Gallons of fuel. Boat comes with 2> 6 Gallon Gas Tanks The boat also has a Trailor in good condition leaf springs, tires and bearings are all in good shape and I would feel comfortable driving anywhere. The only issue with Motor is last year my Manuel assit took a dump. The Manuel assit is a device under the motor that would assit and lock the motor in a tilt position. Since this is no longer in use I have a small piece of preassure treated 1x1 that i slide in that does the same in keeping the motor up in say the locked posotion. Other than this the Motor is Flawless. I built the bow with pressure treated wood last year and then soaked it with many coats of water sealer to protect from weather. I did the same with the floors in the boat. below the bow has an compartment space typically for the anchor but has a ton of room for other thing like rain jackets etc. I installed a 4 swithch panel for lights and accersory and ran all the wires/fuses down side to the 2nd battery. 4 seats inserts are included and installed in the benchs, but seats are not included with the sale of the boat. I converted the livewell in the center of the boat into just a storage for safety supplies, life vest etc. the Stern Bench has a big storage compartment where I tend to keep couple of tackle boxs, bait nets, rain jackets, tows and others. this boat HAS ALOT OF STORAGE FOR IT'S KIND. I have 2 Batteries in the Boat, 1 Deep Cycle Marine Battery behind were I sit to Run the Running Lights, the Lowrance fish finder/chart plotter/depth finder. The second battery Deep Cycle Marine Battery as well as you can see in photos is to run the trolling motor and/or Gigging and shrimp lights.The Gigging Lights/Shrimp light are mounted on the bow and are incluided but can easily be removed if not in use. The Lowrance is also included and works great. I do not have an attena installed so chartplotter/GPS does not work, but depth finder fish finder works great. Also includid is a Motor Guide 46lb thrust trolling motor that is not installed on the boat but can be very easily. The Bimini Top is includid as well and is attached by a track to it can be adjusted to cover more of the bow, or stern, or just middle of the boat. 2 Rod holders are also installed, also I have a trolling Spec fishing rig/rod holder set up above the motor that can be very easily removed on and off. I typically keep it off unless I am spec fishing. 2 tight/losen screws and it slides in and out how ever you like to your pref. This has been a great boat for my family and I and it is time for us to move up to something little bigger. The boat is water ready with no doubts of having any issue and going anywhere in shore or freshwater. Any questions please feel free to ask. Thank you for looking. The boat is listed locally so if sold listing will be removed. thanks, -Mike

12FT JON BOAT 9 HP MOTOR AND TRAILER

$1,900

Tom Bean, Texas

Year -

Make -

Model -

Category -

Length -

Posted Over 1 Month

12 FT Jon flat bottom boat with a 9 HP motor on a tilt trailer. Boat has a fish finder and trolling motor. $1,900.00 firm cash. Boat is in Tom Bean Texas East of Sherman

2012 Alumacraft Riveted Jon 1036

$595

Standish, Maine

Year -

Make -

Model -

Category -

Length -

Posted Over 1 Month

2012 Alumacraft Riveted Jon 1036 If you need a lightweight jon that’s tougher than most jons on the market, look no further. Alumacraft's riveted jon boats are the only choice when you want a boat that’s easy to load by hand and will hold up to years of hard use. You get a proven hull design, reinforced with wider and stronger ribs, and crafted with more than 60 years of riveted boat building experience. Choose from several models of smooth-handling, modified V-hull jons or traditional flat-bottom versions. Add a fast new outboard and let her rip. - 2012 Alumacraft 12ft Jon, aluminum flat bottom boat. Camou.